Haws

Manufacturer: Haws, Manufacturer Part Number: 7501-ConfigSTD-9083 Portable Gravity Fed Eyewash with 9083 The Haws 7501 Cfg STD-9083 compact portable eyewash is a 9-gallon (34.1 L) capacity gravity operated portable eyewash that supplies a continuous flow of water for a full 15 minutes at .4 gpm. This unit is a cost-effective solution ideal for locations without access to potable water, including temporary decontamination sites, temporary treatment facilities, and short-term job sites. The 9083 cleansing stick provides clean water and ANSI compliance in equipment up to 15 gallons (60 L) for up to three years when serviced just once annually. Featuring a FDA approved high-density green polyethylene tank that is easily activated by pulling the yellow activation arm down to the open position A wide-fill opening with a securely threaded cap, and a pronounced 'Max Fill' line permits easy inspection, cleaning and filling Relocation is simple due to 'Lift Here' graphics, easily mounted bracket (included) and light design of this 9-gallon (34.1 L) portable Measurements: 14-1/2" high, 22" wide, 10-1/8" (36.8 x 55.9 x 25.7 cm) deep. *Note: Unit must be wall hung Certified by CSA to meet the ANSI/ISEA Z358.1 Standard for Emergency Eyewash and Shower Equipment. Prop 65 Warning. For California Residents Warning: This product contains a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm.

Manufacturer: Haws, Manufacturer Part Number : 5867Model 5867 fountain regulator is a lead-free plastic pressure regulator currently used on all Haws HO "hands-off" sensor-operated electric drinking fountains. It will maintain a constant stream height with line pressures that vary from 45 - 90 PSI (3.1 - 6.2 bar), and has 1/4" NPT inlet and outlet.

Manufacturer: Haws, Manufacturer Part Number : PBA10The Haws PBA10 push bar is made of ABS plastic and is Tan in color. Soft touch designed bar sends an electrical signal to the solenoid valve on the 1200 series water coolers.

Manufacturer: Haws, Manufacturer Part Number : HCR8Model HCR8 remote chiller is a hermetically-sealed R-134a refrigeration system and is capable of supplying water to a maximum of 2 bubbler stations and is designed to provide 8 gph (30.3 L) of water at 50° F (10° C) +/- 5°. The unit is rated at 115V, 60Hz, and 5 amps. NOTE: For remote installations; locate unit no more than 8ft (2.4m) away from fixtures which it supplies. Chilled water tubing/piping run must be covered with appropriate insulation in order to conserve temperature and avoid condensation.

Manufacturer: Haws, Manufacturer Part Number : 6477The Haws 6477 retrofit filter kit for the 3600 series outdoor pedestal fountains includes the 6428 filter, filter bracket and supply line parts. The 6428 filter is a carbon block filter cartridge with a service life of 1 year/3000-gallons (11356 L). Tested and certified by CSA against NSF/ANSI Standard 42 for the reduction of chlorine (taste and odor) and against NSF/ANSI Standard 53 for the reduction of lead and cysts.

Manufacturer: Haws, Manufacturer Part Number : 6611Model 6611 sand trap shall include a removable lid, hi-density black polyethylene body and fittings, white polypropylene cover with eight vandal-resistant stainless steel screws, cadmium plated steel anchoring nuts, rubber gasket and three anti-skid strips. Cover is intended for foot traffic only. Key is furnished for vandal-resistant screws.

Manufacturer: Haws, Manufacturer Part Number : 6635Model 6635 sand trap shall include a see through acrylic canister with lifting handle for 3500, 3511 and 3600 series fountains. (This option cannot be used in conjunction with the 6250LF bib faucet on 3511).

Manufacturer: Haws, Manufacturer Part Number : VRKHO2Model VRKHO2 is a cable repair kit for HO "Hands-Off" electric water coolers.

Manufacturer: Haws, Manufacturer Part Number : VRKHO3Model VRKHO3 is a solenoid valve for HO "Hands-Off" sensor operated electric water coolers manufactured before October 1st, 2021.

Manufacturer: Haws, Manufacturer Part Number : H7149MSModel H7149MS wall mounting shelf is designed to support most remote chillers in order for chiller to be off the floor and tucked out of the way. Made of heavy gauge galvanized steel. Shelf size is 25 - 1/8" x 13" (63.8 x 33 cm). Note: When installing chiller on shelf in a remote location, adequate air circulation and access must be provided for chiller.

Manufacturer: Haws, Manufacturer Part Number : 6810WModel 6810W is an option for the 68oo in-wall support carrier produced after August of 2023. This custom-fit side drain port can be installed in the field to allow a waste drain to be installed outside of the carrier.

Manufacturer: Haws, Manufacturer Part Number : 5452LFModel 5452LF is a polished chrome-plated brass lever handle, self-closing gooseneck faucet with a vandal-resistant .5 gpm (1.9 L) aerator, vandal-resistant lock pin, and 1/2" O.D. (1.3 cm) slip-joint inlet.

Manufacturer: Haws, Manufacturer Part Number : 5510LFModel 5510LF is a polished chrome-plated brass stay-open lever handle, compression gooseneck faucet with a vandal-resistant .5 gpm (1.9 L) aerator, vandal-resistant lock pin, and 1/2" O.D. (1.3 cm) slip-joint inlet.

Manufacturer: Haws, Manufacturer Part Number : 5551Model 5551 is a self-closing, cold-water gooseneck glassfiller faucet with push-lever operation and polished chrome-plated brass finish, and 3/8" NPT inlet. Mounting hardware not included.

Manufacturer: Haws, Manufacturer Part Number : SK11Model SK11 stainless steel skirt is the outer apron for the 1201 series Haws water coolers (not for "Hi-Lo" units).

Manufacturer: Haws, Manufacturer Part Number : SK13Model SK13 stainless steel skirt is the outer apron for the lower or "Lo" portion of the 1202 and 1212 series Haws "Hi-Lo" water coolers. (For the upper skirt, see model SK12)

Manufacturer: Haws, Manufacturer Part Number : SK12Model SK12 stainless steel skirt is the outer apron for the upper or "Hi" portion of the 1202 and 1212 series Haws "Hi-Lo" water coolers. (For the lower skirt, see model SK13)

Manufacturer: Haws, Manufacturer Part Number : 6433Model 6433 is a lead-free, celcon Y pattern water strainer with removable 100 mesh screen for easy cleaning. 1/4" NPT(F) inlet and outlet. 1-7/8" (4.8 cm) long with strainer arm extending to 2-15/16" (5.6 cm) overall width.

Manufacturer: Haws, Manufacturer Part Number : 6437The Haws 6437 in-line Y-strainer is used for the Haws 1200 series water coolers. The Noryl plastic strainer uses a 100 mesh screen and is attached at the cold water inlet.

Manufacturer: Haws, Manufacturer Part Number : 6438Model 6438 is a three-hole stainless steel strainer nipple used to connect the bubbler head to the valve.

Manufacturer: Haws, Manufacturer Part Number : 6469The Haws 6469 drip tray is used as a retrofit accessory for the Haws 1920 bottle filler when mounting it over the Haws 1109 style of drinking fountains. Easy mounting instructions allow this tray to quickly convert the 1109 series to a bottle filling station. Made of 304 stainless steel, the upper portion can be easily removed, allowing the unit to be cleaned.

Manufacturer: Haws, Manufacturer Part Number : 6800Model 6800 universal support shall include dual steel tube supports with integral 3/16" (.47 cm) steel mounting feet along with u-bolts and hardware.

Manufacturer: Haws, Manufacturer Part Number : 6470This drain kit allows the 2000SMS to be plumbed to a waste outlet. Drain kit includes waste strainer and 1-1/4" (3.2 cm) OD tailpiece and all accompanying washers/nuts to attach strainer to tailpiece. A trap will not be included. Current design of the drain trays allows for pop-out of drain kit assembly.

Manufacturer: Haws, Manufacturer Part Number : 5810The Haws model 5810 cold water control regulates the cold water temperature for the 1200 series Haws water coolers.